[Xerte-dev] Re: FW: Further Xerte Data Loss

Smith, John J.J.Smith at gcu.ac.uk
Mon May 12 16:01:15 BST 2014


NSA filtered me thinks ;-)

Tom and I are working on the new editor just now... should we look at building in some kind of "history"... I'd like to see a undo/redo buttons but should we have a history that persists to server?

Regards,

John Smith | Learning Technologist
Room A251, Govan Mbeki Building | School of Health & Life Sciences | Glasgow Caledonian University
Cowcaddens Road | Glasgow | G4 0BA

Please address ALL support requests to hlsblt at gcu.ac.uk where one of the School Learning Technologists will pick up the job. This will ensure that all jobs are completed as promptly as possible.
________________________________________
From: xerte-dev-bounces at lists.nottingham.ac.uk [xerte-dev-bounces at lists.nottingham.ac.uk] On Behalf Of Julian Tenney [Julian.Tenney at nottingham.ac.uk]
Sent: 12 May 2014 15:55
To: For Xerte technical developers
Subject: [Xerte-dev] Re: FW: Further Xerte Data Loss

Are you on some sort of watch list, where all your mail has to get approved by someone somewhere…?

;-)

From: xerte-dev-bounces at lists.nottingham.ac.uk [mailto:xerte-dev-bounces at lists.nottingham.ac.uk] On Behalf Of Ron Mitchell
Sent: 12 May 2014 15:57
To: 'For Xerte technical developers'
Subject: [Xerte-dev] Re: FW: Further Xerte Data Loss

Note: there has obviously been lots of subsequent discussion but my replies below were sent at 12:33 and seemed to reach the list at 15:45! :-(

From: xerte-dev-bounces at lists.nottingham.ac.uk<mailto:xerte-dev-bounces at lists.nottingham.ac.uk> [mailto:xerte-dev-bounces at lists.nottingham.ac.uk] On Behalf Of Ron Mitchell
Sent: 12 May 2014 12:48
To: 'For Xerte technical developers'
Subject: [Xerte-dev] Re: FW: Further Xerte Data Loss

Very frustrating replying and seeing loads of other replies sent after mine hitting the list before my reply even reaches! :-(

But anyway just re-reading the message from you user and I wonder…

1. Any likelihood of connection problems being the cause?

2. Wondering if rather than connectors or tab nav whether the problem only occurs with page types that have nested pages?


From: Ron Mitchell [mailto:ronm at mitchellmedia.co.uk]
Sent: 12 May 2014 12:33
To: 'For Xerte technical developers'
Subject: RE: [Xerte-dev] FW: Further Xerte Data Loss

I think the fact that it's a connector page in this case might be a red herring. I previously thought it was to do with the tabnav page types but that may be a red herring too.

Yes I've had reports of this quite a few times now (different installations) but haven't been able to nail it down or reliably replicate it except that in Alistairs case it was dodgy connection and so possibly packet loss.

The advice I've been giving is pasted below but I agree it's worrying whenever this happens even though I haven't ever been able to make it happen myself.

Sorry not much help I guess :-(

Guidance example given to one of the HEA projects:
I think you need to provide some guidance to the students to be very careful when authoring if any connection problems are noticed. Also be careful when copying and pasting text into xerte pages or writing code/html. Lost or corrupted pages with xerte are very rare but the occurrences we do know about either happen due to poor connectivity or to code/tags breaking the xml. The key message is do not click publish if any problems are noticed because preview saves the latest changes to preview.xml but these changes are not written to data.xml until publish is selected. So if a problem is noticed not clicking publish can sometimes mean that we can recover from data.xml even if preview.xml has been broken.


From: xerte-dev-bounces at lists.nottingham.ac.uk<mailto:xerte-dev-bounces at lists.nottingham.ac.uk> [mailto:xerte-dev-bounces at lists.nottingham.ac.uk] On Behalf Of Julian Tenney
Sent: 12 May 2014 12:08
To: For Xerte technical developers (xerte-dev at lists.nottingham.ac.uk<mailto:xerte-dev at lists.nottingham.ac.uk>)
Subject: [Xerte-dev] FW: Further Xerte Data Loss


I guys, I need to get to the bottom of this issue: I have a fairly advanced user who has been periodically losing data: the email below explains the problem. A couple of weeks ago it happened and we lost 40 slides, now it has happened again. In the file I looked at, the broken file ended with the characters



<cMen



i.e. an incomplete tag, which I believe should be <cMenuConnector params=”etc”>



Does this ring any bells with anyone? Anyone experienced it before elsewhere? I don’t think the menu connectors are used much, which is why we haven’t come across it before?



I have a feeling it is something to do with escaping characters as data is being saved, or as it is being read back to the editor. Anyone have any other bright ideas how we can troubleshoot it? See below…



Thanks a lot,



Julian





I've experienced further data loss again this morning, this time on a completely different Xerte project (http://www.nottingham.ac.uk/toolkits/play_10189).



I initially produced this resource using the Flash Xerte engine, but the academic I'm working with was keen for me to transfer the data over into HTML5. I made a direct duplicate copy of the Flash project, ticked the HTML5 engine and then set about reproducing the slides - no problem.



Everything was absolutely fine (after working on the project for most of Friday) until around 10:30am this morning, when I lost around 10-15 slides (including my review quiz with 20 MCQs). I'm now beginning to strongly suspect that the Xerte Menu Connector templates might be having something to do with this persistent problem?



I have been using multiple connector menus in both my Grasslands and Meat Science packages. In both I have a dominant 'Main Menu' at the start, which then 'connects' via tabs to several sub-menus (of the same Connector template type) dotted throughout the resource. In each of the sub-menus I link back to the Main Menu.



My last actions before the slides were lost today, happened after I included a further sub-menu connector (at around slide 70) and then linked this to this from the 'Main Menu' (slide 2) via the drop-down selector menu. I then published the changes.



With that being said, I've attempted to recreate the problem using a dummy file, but I have so far failed to do it.


This message and any attachment are intended solely for the addressee and may contain confidential information. If you have received this message in error, please send it back to me, and immediately delete it.   Please do not use, copy or disclose the information contained in this message or in any attachment.  Any views or opinions expressed by the author of this email do not necessarily reflect the views of the University of Nottingham.

This message has been checked for viruses but the contents of an attachment may still contain software viruses which could damage your computer system, you are advised to perform your own checks. Email communications with the University of Nottingham may be monitored as permitted by UK legislation.



This message and any attachment are intended solely for the addressee and may contain confidential information. If you have received this message in error, please send it back to me, and immediately delete it.   Please do not use, copy or disclose the information contained in this message or in any attachment.  Any views or opinions expressed by the author of this email do not necessarily reflect the views of the University of Nottingham.

This message has been checked for viruses but the contents of an attachment may still contain software viruses which could damage your computer system, you are advised to perform your own checks. Email communications with the University of Nottingham may be monitored as permitted by UK legislation.



This message and any attachment are intended solely for the addressee and may contain confidential information. If you have received this message in error, please send it back to me, and immediately delete it.   Please do not use, copy or disclose the information contained in this message or in any attachment.  Any views or opinions expressed by the author of this email do not necessarily reflect the views of the University of Nottingham.

This message has been checked for viruses but the contents of an attachment may still contain software viruses which could damage your computer system, you are advised to perform your own checks. Email communications with the University of Nottingham may be monitored as permitted by UK legislation.


Glasgow Caledonian University is a registered Scottish charity, number SC021474



More information about the Xerte-dev mailing list